(btw.I have never used ASCII modbus, maybe the GE software is Fuji protocol?) 0 is for FGI busĮDIT3: The user parameters are documented in this manual In the attached spreadsheet, you need to enter motor parameters to suit your own motor, and set the modbus address to whatever you want.ĮDIT:- For Serial Control H30 needs to be set to 3, this enables comm control rather than via keypad (btw.I have never used ASCII modbus, maybe the GE software is Fuji protocol?)ĮDIT: Aha! I found it, U49 is RS485 protocol selection. that was the one in the extra manual that I can't find. (sorry I can't remember what it does) but it is critical. ![]() The weird setting, is U49 must be set to 1. ![]() ![]() This is for a Frenic 5000 G11/P11, I am fairly confident that yours will be the same, the few registers I have checked seem the same as yours. Here is a spreadsheet with the drive configuration, you need to enter this from the front panel of the drive, or, maybe use the Fuji configuration software.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |